Metamisk does not go to remix, despite being connected
I have experienced a problem with my Metamk extension Remix, which caused me frustration and inconvenience. Specifically, it is difficult for me to call the contract functions or implement contracts using the Remix interface. In this article, I will explain what is happening and give the decision to solve the problem.
Question: Metamk does not appear
When I try to call the function or install a contract in remix, I notice that the MetamK icon appears as it should. That is, although I am associated with the Remix environment through Metamask. The only visible indicator of his presence is the slightly gray overlay at the top of the browser window.
Troubleshooting steps
To eliminate this problem, I took the following actions:
1
2.
3.
Possible reasons and solutions
After several studies, I found out some of the possible reasons for this issue:
* Invalid Metamask Configuration : It may be that my Metamk parameters are not properly configured by remixes. I checked my account settings and assured them to match the Remix interface.
* Contract permits : I re -used contracts in remixes, but that was not enough to solve the problem. This led me to suspect that a kind of permission may arise with the “metamask”.
To solve this problem, I followed the following steps:
- ** Clean the browser cache and cookies.
- Disable ipwhitelist : I checked that any of my IP addresses is blocked in the remix in the remix by turning off the IP Caucasian.
3.
Conclusion
After performing these troubleshooting steps, I learned that the problem was probably arising from configuration problems with my Metamask Remix extension extension. After verifying my account settings and checking for the permission -related problems, I was able to solve the problem and restore my ability to call the contract functions using the Remix interface.
If you are experiencing similar problems with your Metamask or Remix setup, feel free to share your experience in the comments below!
Leave a Reply